• Mechanical Roving Stop


  • Mechanical Roving Stop is our low-cost solution to get a sensor for elastic or rigid filament combined with roving stop.
  • It’s a closed system, where each device works independently, and without any other sensor or control unit.
  • The system can’t be linked with other options. (eureka; sensorfil or any other option), so, it’s a good solution for small number of spindles and small investments.
  • Works only when machine is working with filament (elastic or rigid)

Special Features

  • Without electronic components: low cost, intuitive functioning and low maintenance.
  • Tested one by one in our mills before delivery.
  • Super easy maintenance: all the components could be open-disassembled-assembled with just a screwdriver.
  • Low cost maintenance: each single component of the roving stop could be purchased alone.


  • Stopping the roving when a filament breakage is detected, the roving stop prevent lappings, new breaks in nearby spindles (when pneumafil suction is blocked), and waste of raw material.
  • With the security to prevent lappings and nearby breaks, it’s possible to reduce the number of operators, increase the machine speed, or find new ways to reduce cost and increase production, something that before was impossible.
  • Payback of the system is really short, especially in coarse counts; expensive materials, or fast delivery production speed.


MRS: Mechanical Roving Stop:
A small LED installed in the roving stop switch ON in the broken positions, making easier for the operator to find the positions than need his work.

Mechanical Roving Stop is a stand-alone system, and is not linkable with any of our other devices.